LAB # 8 (DATA STRUCTURE AND OBJECT ORIENTED PROGRAMING)

LAB # 8

                    CoNTeNT  

TASK Write a program that displays the marks by using class?
TASK Write a program that performs addition by using inline operation? 
TASK Write the program to demonstrate the class using dot operator?


TASK Write a program that displays the marks by using class?

CODE


OUTPUT 
TASK Write a program that performs addition by using inline operation? 
CODE
OUTPUT 


TASK Write the program to demonstrate the class using dot operator?
CODE
OUTPUT
 



Comments

Post a Comment

Popular posts from this blog

Design a boost convertor(dc to dc) input 3.5 to 12 volt and output 24 to 62 volt on multisim

Image
component list 1> 555 timer ic 1> irfz44n MOSFET 1> 1N5822 diode 1> 50uh to 200uh inductor (whatever you want to use in between these values) 1> 1000uf cap capacitor 1> 1k ohm resistor 1> 4.7k ohm resistor 2> 1N4148  1> potentiometer 10k to 100k(whatever you want to use in between these values) 1> 470 pf capacitor 1> 0.1uf capacitor Circuit diagram Results on different voltages  
Read more

How to make a LED flasher by using Transistor BC547 in Multisim || High-quality flasher

Image
 In this article, you will learn about led flashers. Led flasher continuously blinking in nanoseconds. In my designed circuit I used BC547BG Transistor for switching. When the transistor switch is open led will be off state and when the transistor switch is close led will be on the state.  My designed circuit has contained only 5 different color's LEDs. You can add more than 5 LEDs to the circuit Here is the circuit. Input is 9-volt dc and circuit contain 5 Resistor 1k, 5 Resistor 22k, 5 Transistor BC547, 6 22uf Cap Capacitor,  Connect all positive sides of LEDs with a positive side of the supply. The circuit has positive power but on the negative side, the transistor is connected for switching. How make a circuit? First, open Multisim and then place all LEDs like this Then place all the transistors like this. Then place the 22k ohm resistor and 22uf Cap capacitor. Then connect all the components like this. The place the 9 volt supply Now circuit the is complete. Run the...
Read more